Home > Products > Aluminium Rainwater System Gutters > ‘Legacy’ Cast Aluminium Gutter System > Cast Aluminium Gutter – Deep Flow Half Round

Cast Aluminium Gutter - Deep Flow Half Round

Our ‘Legacy’ cast aluminium Deep Beaded Half Round gutters are available in various sizes & are supplied with a complete range of accessories such as angles, outlets, stop ends & various brackets. True & faceted radius gutters are also available.

AB
114 (4 ½")75 (3")

All dimensions in mm (Traditional size in inches)

NumberItem
1Internal Stop End
290° External Angle
3135° External Angle
4Fascia Bracket
5Running Outlet
6Rise and Fall Bracket
790° Internal Angle
8135° Internal Angle
9Side-Fix Rafter Bracket
10Gutter Length
11Union Connector
12Top-Fix Rafter Bracket
13External Stop End

Gutter Length

Gutter SizeAB
114 x 75 (4 ½ x 3")183051*

Stop End - Internal/External

Gutter SizeA
114 x 75 (4 ½ x 3")45*

Union Connector

Gutter SizeA
114 x 75 (4 ½ x 3")94*

Outlet

Gutter SizeA
114 x 75 (4 ½ x 3")195*

90° External Angle

Gutter SizeAB
114 x 75 (4 ½ x 3")15*68*

90° Internal Angle

Gutter SizeAB
114 x 75 (4 ½ x 3")137*185*

135° External Angle

Gutter SizeAB
114 x 75 (4 ½ x 3")15*68*

135° Internal Angle

Gutter SizeAB
114 x 75 (4 ½ x 3")137*185*

Fascia Bracket

Gutter SizeA
114 x 75 (4 ½ x 3")125*

Side-Fix Rafter Bracket

Gutter SizeA
114 x 75 (4 ½ x 3")230

Top-Fix Rafter Bracket

Gutter SizeA
114 x 75 (4 ½ x 3")230

Rise and Fall Bracket

Gutter SizeAB
114 x 75 (4 ½ x 3")200330

Composition and Manufacture

  • Aluminium alloy LM6 to BS5750:2008
  • Marine Grade
  • 100% recycled aluminium and 100% recyclable
  • Special fittings can be provided
  • Mill finish or powdercoated to specific RAL/BS colour
  • Lightweight

Installation

Cast Deep Beaded Half Round gutters have fascia brackets which are set out at 915mm maximum centres no further than 300mm from a joint on gutter runs. Please allow one extra bracket per fitting.

The fascia brackets should be set out to any pre-determined fall taking note of the position of any fittings such as outlets & angles beforehand, brackets should be fixed using M5x25mm stainless steel countersunk screws (dependant on substrate).

Top fixing or side fixing rafter brackets are also available whose centres may be governed by the roof timbers.

Rise & fall brackets driven into the masonry are recommended to be at 915mm maximum centres.

Touch up is supplied to coat all cut edges.

Full installation instructions are supplied with every delivery.